Resume Service Action—Setting Properties

The Resume Service action is used to resume a service after is was paused using a Pause Service action.

To set Resume Service properties

  1. From the Task Builder Available Actions pane, open the Services folder and double-click the Resume Service action or drag it into the Steps pane.

  2. In the Service to resume box, select the service to resume.

  3. To include device and file system drivers, select the Include device and file system drivers check box.

    Warning
    : Do not include device and file system drivers unless you are familiar with them and fully understand what the result will be.

  4. To set the Description tab properties, refer to Description Tab Options.

  5. To set the Error Causes and On Error tab properties, refer to Step Error Handling.

  6. When finished, click OK to save settings and close the properties dialog window.

See Also

About Actions

Adding Task Steps

Resume Service Action